Common Rail 3200677 Injector Encyclopedia Knowledge

Fuel injector 3200677 is the most critical and complex part in common rail system, and it is also the most difficult part in design and process. By controlling the opening and closing of the solenoid valve, the ECU injects the fuel in the high-pressure fuel rail into the combustion chamber with the best fuel injection timing, fuel injection quantity and fuel injection rate.

In order to achieve an effective of 3200677 injector’s fuel injection starting point and precise fuel injection quantity, common rail system uses a special fuel injector with hydraulic servo system and electronic control element (solenoid valve).

The fuel injector 3200677 is composed of an orifice nozzle which similar to traditional fuel injector, a hydraulic servo system (control piston, control metering hole, etc.), a solenoid valve, etc.

3200677 Injection Reasons of Not Working Normally

There is air in the oil circuit of the engine fuel system.
Vehicle oil pump oil supply system is not normal.
Engine common rail system oil leakage or pressure limiting valve damage.
There is a short circuit, cutting out and poor contact in the wiring harness connected to the fuel injectionof the vehicle.
The long-term placement of the injectioncauses the anti-rust oil to solidify, and the internal components are stuck or the oil holes are blocked.

Before installing, carefully check whether other components in the common rail system except the fuel injection are damaged so as to prevent the fuel injection from not working properly after being replaced.

3200677 Injection Causes to Damage

Don’t operate properly according to engine maintenance manual during dis-assembly or installation, resulting in damage to the injection.
The fuel oil used for the vehicle does not meet the standard cause damage to the injection, such as: the water content in the fuel oil exceeds the standard, iron powder, aluminum powder, sulfide impurities exceed the standard, etc.
The engine is not regularly maintained according to the engine maintenance manual (please refer to the vehicle maintenance manual for the maintenance mileage). For example, failure to replace the lubricating oil of the engine system for a long time will cause abnormal wear of the engine, excessive exhaust gas volume or a large amount of carbon deposits inside the engine. The filter is not replaced during maintenance or the replaced filter cannot reach the original filter standard. all above reasons can cause damage to the injection.
The abrasion of the oil pump produces iron powder and aluminum powder enter the fuel injectionand cause damage to the fuel injection.
The deformation and abrasion of fuel tank result in iron powder or aluminum powder entering the fuel injectionand causing damage to the fuel injection.
The fuel injectionis damaged due to replacement or adjustment of the relevant parts of the fuel injection. For example, the valve clearance does not meet the standard after the engine is repaired, the replacement or modification of the wiring harness connected to the injection fails to meet the original standard.
The engine is overheated and overloaded for a long time working results in damage to the fuel injection.
The injectionwill be damaged naturally at the end of its working life.
The injectionis magnetized (injection parts’ magnetic exceeded) causing the injection to not work properly.

Before replacing the fuel injection, please check the engine parts carefully according to the engine maintenance manual to avoid the fuel injection being damaged again after replacement.